Epotec U-100

PRODUCT DESCRIPTION

Epotec U-100 is a fine, white finishing plaster mix based on cement, enriched with additives that enhance the product's usability and provide high adhesion. It complies with TS 13687 standards.

APPLICATION AREAS

This product can be used as a final coating plaster for ceilings and walls, both indoors and outdoors. It is suitable for surfaces made of concrete, aerated concrete, brick, briquettes (compressed coal, peat, or ore in brick form), cut stone, gypsum partition boards, and other masonry materials. It can also be applied as a fine plaster over surfaces previously coated with A 250 primer or rough plaster on building facades and stone fences.

ADVANTAGES

U 100 provides a smooth, even, flawless, and glossy finish.

There is no risk of dust formation.

Environmentally friendly and harmless to human health.

Easy to prepare and apply.

Does not require the addition of PVA glue or other additives.

Does not spill during application and provides an aesthetically pleasing experience for the craftsman.

Does not crack.

It is durable and flexible.

INSTRUCTIONS FOR USE

Surface preparation: Ensure that the surfaces are sound, dry, clean, and properly dimensioned. All types of oil and paraffin residues that weaken surface adhesion must be completely removed. Before applying the finish, the surface should be primed with A 250 or another appropriate repair mix produced in accordance with standards. The surface should also be pre-moistened with water, Binder, or another standard-compliant product.

Mix preparation: Pour 20 kg of U 100 into 9-9.5 liters of water and wait for 3-4 minutes. Then, mix until fully blended using a mixer or manual tool. Once the mix is ready, do not add any additional dry mix or water.

Application: Apply the prepared U 100 plaster mix to the wall or ceiling previously primed with A 250, using a trowel. Use the mix within 80-100 minutes. Any mix that has hardened or formed a crust is unusable.

Recommendations: While applying the plaster, ensure that the ambient and surface temperature is at least +5°C. If the ambient temperature is below +5°C or above +30°C, necessary temperature adjustments should be made. Do not apply in hot (+30°C or higher), rainy, or windy conditions. Ensure that the containers and tools used for mixing are clean, as contaminated equipment can reduce the working time of the mix and negatively affect the product's quality. It is recommended to clean tools with water immediately after use. Be cautious to avoid marks from the steel trowel during application.

CONSUMPTION

To achieve a smooth and even surface with a 1 mm thickness, 1.7 kg of U 100 is required per square meter. One 20 kg bag of U 100 plaster mix is sufficient to cover 11 m² of smooth surface.

STORAGE CONDITIONS AND SHELF LIFE

Packed bags should be stored in dry warehouses on wooden pallets, with no contact with the floor, stacked up to a maximum of 10 units. The shelf life is 6 months.

WARRANTY AND TECHNICAL SUPPORT

The information provided in the technical specifications is based on scientific and practical knowledge. EPO guarantees that the product complies with relevant technical conditions and state standards. However, EPO is not responsible for any issues arising from improper use outside the provided instructions, except for cases where work is supervised by company specialists. EPO reserves the right to make changes to the product in line with scientific and technical advancements. For technical support or more detailed information, please contact EPO.